Wiring 3 Way Switch. Turn off the power at the service panel. Best of all, they are easy to install.
How To Wire a 3Way Light Switch Family Handyman from www.familyhandyman.com
Web three way switches are used any time two switches are needed to control a light. The ground wire is pigtailed with a wire connector at the switch boxes and the ceiling box. Note the black tape (or paint) on the white wires that are used as switched hot instead of neutral.
The Black And Red Wires Connect The Two Switches.
When the toggles from both switches are up or down, the circuit is complete and the light will be on. Best of all, they are easy to install. Match the wires to connect the circuit wires to the fixture.
Attach The Ground Wires To The Ground Screw By Using Green Hole Wire Nut.
Once you're done, you'll be able. The colors will vary depending on whether nm cable or conduit was used. Note the black tape (or paint) on the white wires that are used as switched hot instead of neutral.
Pull Out The Old Switch.
Turn off the correct circuit at your electrical panel. It’s likely you’ll also need to replace the. Have the black and red wires of 14/3 attach with silver or gold screws.
The First Step Is To Run The White, Ground, And Hot Wires From The Power Source To The First Switch.
Turn off the power at the service panel. When they are opposite, the circuit opens and there will be no light. The conventions and wire colors are for the u.s.a.
Web Connect Both White Wires, Connect 14/2 Wire’s Black Wire To Light’s Black Common Screw.
The power source will enter at either the light fixture or at one of the switch boxes. Tuck those wires nicely and get the switch box installed. With conduit, the wire colors for travelers could be any color.
